I used it on 2017 Ford transit 250 Tool itself is great helper and I believe that it has the sturdiness needed it for the job it is made for. It does not have any instruction, probably because it is mainly used by professionals only, so regular lesson may struggle a little too correctly assemble and also use it to the point that it evil be bent or damaged beyond use. First and foremost, keep in mind, that you not trying compress the poison, it must be wind only and direction off winding is different for passenger and driver side (caliper has imprinted arrow to navigate you which direction to use). Also keep in mind, that you compresing brake fluid trough combination of rubber and metal tubing with tiny diameter inside = you will feel the resistance!! Before you start the winding back open brake fluid reservoir to allow three compressed fluid go back in much easily. Now at some point you may feel, that it won't continue winding = strong resistance, so wait a little, adjust the tool again so it will not be too tight or too loose and try again..... it will continue again smootly. If you feel strong resistance once again,.. wait adjust and keep going again. With enough patience and your sensitive hands tool will work flawlessly as it is designed. I strongly disagree with person who bent this tool doing same job as me, it's not the tool fault! it's the human factor again and again..... This tool will do compresing or winding, you just have to know what your caliper need and hose to use this tool. 2-25-2020 Correcting: instruction is actually included inside of the box, just was ignored at the moment of first look and eagerness to try it out. Also I tested on 4 human beings ability of using the tool not knowing what it is or does. Age differences were from 7-43Y old. All received same simple info and task. 1rst task: they had to pick only 3 pieces from the box, which are needed it for the tool to function. Result = all failed 2nd task: assemble toll from the 3 pieces and make it functional Result=all succeeded in time line from 1-15 minute. 7Y old boy need it 15minutes for assembly 9Y old boy need it 1+minute 11Y old girl need it about 13 minutes Grown up women need it only 5 minutes, so adult men, who is complaining about not being able to solve it without another adult should not write negative rewiew....., especially when instruction is included. Enjoy the video of small boy to show you how to assemble it correctly.
My motorcycle.
Worked perfectly
The tubing was fine but adapters supplied to attach to bleeder valve are not suitable for my ATV bleeder valve. Too large!!! Although the kit is well supplied with adaptors the smallest adapter was not able to create a proper seal to create enough vacuum to pull fluid through system. If only the kit included a type of reducing connector from the supplied tubing to a smaller diameter tubing the kit would work better. And perhaps an additional smaller connector.
4pcs 4x156 ATV Wheel Spacers, 2 Inch Wheel Adapters with M12x1.5 Studs